Browsing by Author "Jiang, Qiuhong (TTU)"
Now showing 1 - 2 of 2
- Results Per Page
- Sort Options
Item Energy consumption and saving analysis for laser engineered net shaping of metal powders(2016) Liu, Zhichao (TTU); Ning, Fuda (TTU); Cong, Weilong (TTU); Jiang, Qiuhong (TTU); Li, Tao; Zhang, Hongchao (TTU); Zhou, Yingge (TTU)With the increasing awareness of environmental protection and sustainable manufacturing, the environmental impact of laser additive manufacturing (LAM) technology has been attracting more and more attention. Aiming to quantitatively analyze the energy consumption and extract possible ways to save energy during the LAM process, this investigation studies the effects of input variables including laser power, scanning speed, and powder feed rate on the overall energy consumption during the laser deposition processes. Considering microhardness as a standard quality, the energy consumption of unit deposition volume (ECUDV, in J/mm3) is proposed as a measure for the average applied energy of the fabricated metal part. The potential energy-saving benefits of the ultrasonic vibration-assisted laser engineering net shaping (LENS) process are also examined in this paper. The experimental results suggest that the theoretical and actual values of the energy consumption present different trends along with the same input variables. It is possible to reduce the energy consumption and, at the same time, maintain a good part quality and the optimal combination of the parameters referring to Inconel 718 as a material is laser power of 300 W, scanning speed of 8.47 mm/s and powder feed rate of 4 rpm. When the geometry shaping and microhardness are selected as evaluating criterions, American Iron and Steel Institute (AISI) 4140 powder will cause the largest energy consumption per unit volume. The ultrasonic vibration-assisted LENS process cannot only improve the clad quality, but can also decrease the energy consumption to a considerable extent.Item Feasibility Exploration of Superalloys for AISI 4140 Steel Repairing using Laser Engineered Net Shaping(2017) Liu, Zhichao (TTU); Cong, Weilong (TTU); Kim, Hoyeol (TTU); Ning, Fuda (TTU); Jiang, Qiuhong (TTU); Li, Tao; Zhang, Hong-chao (TTU); Zhou, Yingge (TTU)Due to high strength and ductility, AISI 4141 alloy steel is widely used in many industrial applications, such as gears and blades. When it is composed to harsh working environment, severe mechanical failures may happen. In order to save the high added value of the components, necessary repairing techniques are required to recover their functionality. Laser Engineered Net Shaping (LENS) is an innovative technology for metal parts repairing and rebuilding due to its metallurgical bonding and exhibit heat affected zone (HAZ). Compared to other repairing processes, LENS cannot only reduce the manufacturing time and cost, increase material utilization, but also provide an outstanding as-fabricated mechanical properties. Considering the compatibility and availability of powder materials, the selection of to-be-fabricated materials are important and decisive to the mechanical properties and the quality of the deposits. In this investigation, nickel-based and cobalt based superalloys are deposited onto AISI 4140 steel substrate using laser engineered net shaping (LENS) process to verify the feasibility of these superalloys for repairing of AISI 4140 workpieces. The micro-hardness, tensile strength, fracture and wear resistance are analyzed to testify the resistance of deformation, tension and anti-friction performance of deposited materials.